poppy1440
03-20-2010, 02:37 PM
Hello
I'm installing a powerlogger and plx wideband on an 86 GN with digital dash & 3bar MAP. I just want to double check connections.
#2 on input block spliced into green wire from PAC(alky) measures 1.6v with key on engine off.
#7 on input block is connected to white wire from scan master version 2.2
bung installed in exhaust
power supplied to plx plug
here's my question how do I connect the P.L. to the wide band? I think it's through the 4 pin analog connector supplied with the plx I'm just not sure how to make this connection. And if ya'll see anything else I may have missed any help will be grately appreciated
Thanks
I'm installing a powerlogger and plx wideband on an 86 GN with digital dash & 3bar MAP. I just want to double check connections.
#2 on input block spliced into green wire from PAC(alky) measures 1.6v with key on engine off.
#7 on input block is connected to white wire from scan master version 2.2
bung installed in exhaust
power supplied to plx plug
here's my question how do I connect the P.L. to the wide band? I think it's through the 4 pin analog connector supplied with the plx I'm just not sure how to make this connection. And if ya'll see anything else I may have missed any help will be grately appreciated
Thanks