Keller
10-03-2010, 09:56 PM
I have an early Powerlogger EGT adapter, and an going to try (yet) another EGT probe with it. However, its leads are attached to the probe, and look to be a little shorter than I'd like. They wont' reach into the cabin, at least not where I currently have the EGT adapter.
Is it OK to move the adapter closer to the EGT location and extend the adapter wires? The EGT wires will not be touched. I don't see how this would affect anything, but just want to do a head check. I want to avoid the engine compartment, but currently have the adapter in the glovebox, which makes routing difficult.
Is it OK to move the adapter closer to the EGT location and extend the adapter wires? The EGT wires will not be touched. I don't see how this would affect anything, but just want to do a head check. I want to avoid the engine compartment, but currently have the adapter in the glovebox, which makes routing difficult.