PDA

View Full Version : Vacuum Line Correct Routing!!!


Ron84TType
05-25-2005, 07:21 PM
Hey Guys,

I have an 84 T-Type and i do have diagrams of the routing of the vacuum lines for the 84-85's. There are a few different ones i printed out that all seem a little different at how the lines are routed and where they go.

All the printouts are kinda hard to view perfectly to see if they have y connectors and such. So my question is, do all the lines going from the EGR selinoid go to the EGR? Does the PCV valve line go directly to the vacuum block or does it have a T in it for another line? I am using the single wastegate line setup. Also the vacuum tee that comes out of the EGR selinoid is that a 4 port elbow vacuum connector? If it is, im not sure where to get one. If you look at the diagram you can see its kinda hard to see where the placement is for the lines by the driver valvle cover. If there was a backside view, might make it easier. Just had to ask a few questions on items that im sure people have had alot, but they were just stickin in my head and had to get them out.

Thanks to all who reply.

Ron
http://www.engraver1.com/help/intake2.gif

SLOW_85
05-26-2005, 12:43 AM
Some more diagrams:
http://www.geocities.com/gnowner85/info.html

The wastegate solenoid will tee into the PCV valve line from the block.
(port on passenger side)
The EGR has 3, first on driver's side runs to middle back of vacuum block.
The other 2 run to the hard metal line.
If you don't have the connector should be able to use short hose and some L's or T's or a Y to connect.
HTH