PDA

View Full Version : Which warning lights are supposed to flash?


baller760
06-01-2005, 12:51 AM
I pulled my dash off and replaced the bulbs and the sockets, and most of them work now except for a few. The one I'm the most worried about is my SES light. It doesn't turn on when I turn my key so I have no idea if I'm throwing codes. I replaced the bulbs and the sockets so where else can I look? The whole left side seems to light up now, even the low fuel light. Except the oil and water temp. The only thing that works on the right side is the right turn signal. all of the others don't light at all. What could be the cause????

Keller
06-01-2005, 01:05 AM
Oil and water lights may have been disconnected by someone who connected those sensors for gauge sensors.

"Power Injection" and "Car Is Leveling" aren't supposed to light up...

"Low Fuel" could have been field installed.

See http://www.gnttype.org/maint/malf.html to force your SES to flash and find out if it works or not.

baller760
06-01-2005, 01:17 AM
Yeah, I've tried that but when I turn the key the light doesn't even turn on like it's supposed to. And when I ground it the light doesn't flash or anything.

Keller
06-01-2005, 02:34 AM
Dig in and start figuring out what is wrong. There must be a break somewhere.

http://www.gnttype.org/techarea/electrical/wiring.html