Thread
:
200-4R Rebuild ... step by step!
View Single Post
#
21
03-19-2009, 04:22 AM
jakeshoe
The Trans Guy
Join Date: Aug 2007
Location: Texas
Posts: 25
Re: 200-4R Rebuild ... step by step!
Now the low support can be installed. There is a feed hole and wide spline. This faces the valve body or bottom side of the case. This is best accomplished using a support installer/remover tool as shown but can be done by other means.
Now the beveled snap ring needs to be installed to hold the low support housing in place.
jakeshoe
View Public Profile
Send a private message to jakeshoe
Visit jakeshoe's homepage!
Find all posts by jakeshoe