View Single Post
  #21  
Old 03-19-2009, 04:22 AM
jakeshoe jakeshoe is offline
The Trans Guy
 
Join Date: Aug 2007
Location: Texas
Posts: 25
jakeshoe is on a distinguished road
Default Re: 200-4R Rebuild ... step by step!

Now the low support can be installed. There is a feed hole and wide spline. This faces the valve body or bottom side of the case. This is best accomplished using a support installer/remover tool as shown but can be done by other means.





Now the beveled snap ring needs to be installed to hold the low support housing in place.
Reply With Quote