|
|
||||||
|
|||||||
|
|||||||
|
|||||||
| This is a general site search and does not include list archives. | |||||||
|
|
|
|
|
||||
|
#1
03-20-2010, 02:37 PM
|
|||
|
|||
power logger install question
Hello
I'm installing a powerlogger and plx wideband on an 86 GN with digital dash & 3bar MAP. I just want to double check connections. #2 on input block spliced into green wire from PAC(alky) measures 1.6v with key on engine off. #7 on input block is connected to white wire from scan master version 2.2 bung installed in exhaust power supplied to plx plug here's my question how do I connect the P.L. to the wide band? I think it's through the 4 pin analog connector supplied with the plx I'm just not sure how to make this connection. And if ya'll see anything else I may have missed any help will be grately appreciated Thanks
__________________
86 gn. 9 inch k&n, walbro 255 hotwired, adjustable wastegate with vacumn controller, stock location stretch intercooler, scan master, 42.5lbs injectors, 3 inch downpipe, tt chip, julios alky, ta 49 
|
|
#2
04-06-2010, 04:08 PM
|
||||
|
||||
|
Re: power logger install question
You want to consult the PLX manual and find out which one is the 0-5V analog output. Connect that to the PL input block.
__________________
Alan Minga: Lacey's Spring, AL 86 Buick Regal T-Type
|
 |
| Bookmarks |
|
|
Linear Mode
