View Full Version : Engine Electrical/Ignition
- Rough Idle
- plug wire placement on coil pack
- No start. Need Help!
- timing problem
- Unknown Sensor
- type II ignition
- 86 ttype starts about every 10th try
- Wire to IGN terminal in fuse box?
- timing???
- Is 12.5 Volts at WOT Normal?
- Trouble Code 42
- retro wiring harness
- A couple of MAF questions...
- ECM dead???
- 1.21 gigawatts
- Can't beat 15.40 please help.
- GN 84 alternator upgrade ?
- Need Help!!!
- Drivability issues
- Knock guage
- crank sensor?
- Still have the demons!
- brake light, engine light
- tachometer frustration
- Gonna shoot it (electrical?)
- O2 voltage at idle
- Injector #s
- One question!
- Wells coil pack
- caspers vss and converter box
- MAP sensor
- no spark...
- msd box ?
- Code 51; GNX prom
- sputtering at 2800rpm
- Scan master turns on..then shuts off.?????
- no power, rough idle??? code 42
- Air Conditioner Compressor Sensor
- VSS Question
- backfiring
- wide band 02
- Gremlins!
- Left side plugs fouled.
- 85 Full Throttle Gn- Missing Like Crazy
- Mechanic/Technicial Wanted
- 84 Wh1 Spuddering A Lot
- Please help me I.D. a connector
- 84 GN No Start....
- Sensor Problem?????
- `808 map to `165 maf conversion ???
- Passenger door connector wire diagram on 84 GN
- Full Throttle Gn!
- ECM not learning?
- need tr mechanic
- Wastegate Control Solenoid
- Looking at a LS1 MAF for my '87 T-Type
- charging problems
- Need firing order!
- No spark
- Spark plug gap
- 86 ttype starts about every 10th try: UPDATE
- Help electrical problems
- Spark Plugs
- coil pack question
- Backfires and won't start!
- knock problems!!!!!!!!!!!!
- Alternators
- spring tune up.
- engin troubles
- poping dead miss, at -5 to o vacuume
- Code 42.....still runs
- tach all bars stuck on
- Where Is The Crank Sensor
- won't start
- will not start if hot
- Ecm Connector sizes
- wiring with relays for N2o and etc..
- Need help identifying sensors (pictures within)
- Cam and crank sensors, HOW do they work?
- ground touching electrode
- Unknown sensor and wires???
- vss
- Which warning lights are supposed to flash?
- EGR Question
- o2 sensor thread size
- Price For New Maf
- ECM Solenoid Fuse Blowing
- Too Much Boost
- never ending drama
- MSD Timing question
- Tach light all the way on
- Problems, Problems, Problems!
- quick timing question
- I screwed somthing up. Need some help
- hi torque starter...
- Stock Ignition Limititions
- problem
- ot guages again
- translator or translator + ?
- my electric fan isn't kicking on
- esc module
- engine misfires,fan not working
- fan delay relay
- Plug wire suggestions please.
- Electric Fan
- Ignition problems
- Microtech MAF and low o2s at WOT
- MAF Translator Pro ?
- No start - Hybrid car
- h2o temp and oil pressure install
- Confured: New battery/alt going dead
- Car has NO POWER!
- ecm/ign fuse blowing
- GM coils - made in CHINA???
- wire connections
- help
- Cam sensor low voltage
- misfire, please help
- 87 GN Misfires at 2800 rpm
- poping/hesitation
- new style coils, what works?
- Wire core or carbon core plug wires?
- EGR code set in ECM
- 87GN misses at idle
- bucking at 3500
- My 85 T Type Lost All Its Spark???
- wastegate solenoid
- aftermarket parts
- Sensor Problem?
- GNX O2 Sensor
- Cam Sensor ????
- LS1 MAF / Translator
- knock sensor
- 84/5 to 86/7 ecm questions
- coil pack/ignition info
- GN up and DIED on me...
- Another dead GN
- Tps Enhancer??????????
- Part number/name for alt wire across front of oil pan.
- Mas Air Cleaning?
- recommend me spark plug wires
- skipping
- Crank Sensor Question
- voltage boosters
- EST Signal Wire....
- help with bmalfunction code 23
- ecm bull S#$t
- Code 41 Help
- car cuts out pops at 4800 rpms only 2nd 3rd gear
- cam sensor problems
- dies at WOT and sometimes cruizing
- hesitation/misfire problem
- #42 code, where do i start?
- Where can i get an ECM?
- running erraticly
- code 41
- Engine wont crank
- Major hesitation
- What is this sensor?
- Tps Quest.
- distributor
- IAC counts question
- Scanmaster 02 millivolt readings
- Oil Pump Sensor
- fuel pump fuse blows immediately...
- Resistors On Maf Sensor Plug
- Newbie boost question
- Different ignition module wiring for '87 TR??
- idles fine but won't go
- HELP! 89 Lebaron Wont Start, fault codes 44,37,43,25
- diagnose ignition
- these new 'chips'....
- Iac Reset
- DIY kill switch
- Alternator
- What happened?
- Coil Packs
- msd box
- oil pressure sensor plug replacement
- ozzzzzzzz
- IAC and TPS adjustment
- No Spark or Fuel
- Cam Sensor Replace/Adjust - How?
- Help Service Engine
- car died, wont start
- heater,ac only blowing through lower vents
- MAF readings
- Esc Module
- Not starting....looong time issue
- electrical tempature guage
- Alt checks out, Bat checks out...what gives!?
- Heater problem
- Boost gauge light wire up
- Keller!! Another Electrical ?
- replaced cam sensor and wont start
- o2 sensor shot?
- Coil pack ignition module goo
- 86/87 Cam Sensor vs 84?
- Crank Sensor Removal And Install
- NO START! 84 grand national
- Bosch 02 sensors
- My MAF just failed ...
- General overview on the ECM's program flow?
- You gotta be kidding me!!
- o2 sensor questions
- Knock
- Elect fan question
- Electric FP gauge??
- vacuum hose problem for 87 gn
- Autolite spark plugs?
- Anyone ever seen a VoltBooster fail?
- Yeah, so I'm a dumba$$
- back firing under a load
- 87 GN No Start
- fuel canister with vacuum plug
- knock alert
- Cleaner engine bay worth the trouble?
- aftermarket temp sender location
- battery cables
- battery problems
- timing adv-ret
- IAT sensor installation
- Aftermarket coil packs
- Spark plugs
- ??clue-less??
- Power enrichment ?s
- PE vs. coolant temp
- Knock went crazy
- MAF sensor calibration
- Wiring Mystery
- Cam sensor problem
- map sensor?
- No fuel pump on start up
- TPS sensor/caspers
- Setting initial timing? '87 3.8 Turbo
- replacing coil pack
- Tweaking for maximum tune ?s
- Need to Eliminate Cold Start Rough Idle
- Ignition problem, help....
- is my coil bad?
- Installing a Tach...
- no spark
- Stock Boost gauge on digital dash.
- still no spark
- stock digital boost gauge not reading
- MAL code 15 on the Scanmaster!!!
- Knock Sensor Lights?
- Help Please.
- What's going obsolete?
- OK to wire gauges in tandem?
vBulletin® v3.7.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.