PDA

View Full Version : Alternate fuel line routing


hrhoward
10-10-2006, 03:02 PM
I would like to know of alternate methods / locations for a fuel feed line. I know someone out there has done this and would like some suggestions please.

Thanks.
H. Howard

PaCemkr86
10-10-2006, 03:36 PM
i ran AN fittings and steel braided lines under the hood of my buick

PaCemkr86
10-10-2006, 03:38 PM
http://www.ccstreetscene.com/multimedia/phil/tubeaarm2.JPG

NOTACARLO
10-10-2006, 09:56 PM
I used AN fittings at the rail and then ran some 5/8" 3000 psi high temp line from the fuel cell along the passenger side frame rail. Weaved it in and out of the frame, then followed the original fuel return/feed line location. I also use a large spin on fuel filter in the trunk area. The fuel line is braided steel, but it is underneath a coating of rubber. I also used the line with teflon inner lining. Sorry if this is too much info, but I am quite proud of this set up (so if the car burned to the ground, the fuel system would be the only thing left!).

PaCemkr86
10-10-2006, 09:58 PM
http://krylonracing.com/paceGN/ttype%20003.jpg

http://krylonracing.com/paceGN/ttype%20004.jpg

PaCemkr86
10-10-2006, 10:07 PM
sorry the pics are so big, they were hard to see smaller

hrhoward
10-13-2006, 11:01 AM
Thanks PaCemkr86 and NOTACARLO!
Another question, what are the sizes of the fittings? At the fuel rail and the line from the frame.

Thanks

PaCemkr86
10-13-2006, 03:41 PM
i have that info written down at home..

Ps the rubber fuel line you see in the pic is going to a fuel pressure test gauge, i forgot to remove it before i took the pic, sorry for any confusion