power logger install question
 

Hello
I'm installing a powerlogger and plx wideband on an 86 GN with digital dash & 3bar MAP. I just want to double check connections.

#2 on input block spliced into green wire from PAC(alky) measures 1.6v with key on engine off.

#7 on input block is connected to white wire from scan master version 2.2

bung installed in exhaust

power supplied to plx plug

here's my question how do I connect the P.L. to the wide band? I think it's through the 4 pin analog connector supplied with the plx I'm just not sure how to make this connection. And if ya'll see anything else I may have missed any help will be grately appreciated

Thanks

Re: power logger install question
 

You want to consult the PLX manual and find out which one is the 0-5V analog output. Connect that to the PL input block.